Black 7" Round LED Projector Headlights For Jeep Wrangler JK TJ LJ H4 H13 07-15

Specifications

Black 7" LED Projector Headlights Hi/Lo Beams With Halos For Jeep Wrangler & Land Rover Defender

1 complete kit includes:

1 x pair of 7" LED headlights

1 x pair of H4-H13 adapters

1 x pair of decoders

1 x set of wire harness for angel eyes (the halos)

Parameters:

Power: 40W @ high beam; 20W @ low beam

Type: 7" round black inner bezel headlight for Jeep

Connector type: H4/H13 for Wrangler

Luminous flux: 3980lm @ high beam; 1900lm @ low beam

Working voltage: 10-30V DC

Multifunctions: angel eyes (white light DRLs) + turn lights (amber turn lights)

Fitment:

Jeep Wrangler TJ JK LK

Land Rover

Harley Davidson Motorcycle

Hummer H1 H2 H3

Mercedes Benz G500 G55

Unimog U5000

Old Beetles

VW T3 Bus

As well as other vehicles with 7 inch headlamps

About the angel eyes:

Daytime running state it is normally white, when you turning signal, the corresponding side halo becomes to be yellow(amber) and flashes at same frequency as original car's signal turning lights.

It is both ok for LHD (Left Hand Drive) & RHD (Right Hand Drive).

AND MORE:

Please note that the headlight each with two(or 4) breathing holes covered with waterproof breathable composite fabric cloth, that means it prevents water to drop in, but let air (includes water vapor) in and out, so you will find sometime the inside of the headlight just behind the lens cover becomes foggy, please don't worry about that, it just because the headlight inner is hot but outside is cold, water vapor coagulates on the inner cover, and if inside and outside temperature come to close, the water vapor will disappear, it is normal.

Headlight Diameter: 7"

Height: 3.85"

G.W.: 3.5 Kgs

Carton Size: 380*260*150mm

Quality Warranty: 12 months (damage or loss due to human errors are not covered)

Installation schematic diagram：

Easy to install it, just plug & play.

How to make the Jeep lights' halos (DRLs) work automatically?

We can do this:

Use our intelligent DRL wire harness, and connect with the halos, you can get the Jeep lights work automatically, check the following video tested in lab:

So, you don't have to find out the ACC port hardly in the fuse box, you only need to connect the wires to the battery and you can make the halos automatically on / off. And if you connect the turn lights, headlight low beam and horn, you will get automatical multifunction halos Jeep lights, work similar as in the video. This type of intelligent wire harness is also available for other types halos lights, for all of the halos work same as ordinary DRLs in vehicles.